(18) Click the Logout button on the screen and switch back to standby mode.
(19) On the Scanner Parameter page, input the parameter values for 240 mm/s and 120 mm/s
that you saved earlier and execute SetParam.
(Parameter settings for monochrome)
After entering the
values, press the
button to set them.
Set the following values.
ASC67: Result of the scan images 1 and 2, at Monochrome 240 mm/s
ASC69: Result of the scan images 3 and 4, at Monochrome 120 mm/s
ASC71: Result of the scan images 3 and 4, at Monochrome 60 mm/s
ASC73: Result of the scan images 3 and 4, at Monochrome 40 mm/s
Set the following value: Result of the scan
images 3 and 4, at Monochrome 6 0mm/s
Chapter 11 Scanner Calibration
11-25