Oki LP-1040 Maintenance Manual page 90

Calibration to Identify Roll Width
Number
649 The Printer detects the distance between the
right and left flange guides and calibrates it to
650
the identified value.
In this category, the right flange is moved to
651
the leftmost position, and the left flange to the
652
rightmost so that the distance is minimized.
653 The Printer detects the distance between the
right and left flange guides and calibrates it to
654
the identified value.
In this category, the right flange is moved to
655
the rightmost position, and the left flange to
656
the leftmost so that the distance is
maximized.
Number
657 Number of bytes in left end mask
Adjustment method
Decreasing the value: Decreases the mask area of the
left edge of the printing area.
Increasing the value: Increases the mask area of the left
edge of the printing area.
Adjustment criteria
If 10 is input, the area is masked about 5 mm.
658 Number of bytes in right end mask
Adjustment method
Decreasing the value: Decreases the mask area of the
left edge of the printing area.
Increasing the value: Increases the mask area of the left
edge of the printing area.
Adjustment criteria
If 10 is input, the area is masked about 5 mm.
659 Number of front end mask lines
Adjustment method
Decreasing the value: Decreases the mask area of the
head of the printing area.
Increasing the value: Increases the mask area of the
head of the printing area.
Adjustment criteria
If 100 is input, the area is masked about 4 mm.
660 Number of rear end mask lines
Adjustment method
Decreasing the value: Decreases the mask area of the
head of the printing area.
Increasing the value: Increases the mask area of the
head of the printing area.
Adjustment criteria
If 100 is input, the area is masked about 4 mm.
662 Excessive process cartridge usage warning
Description
Description
Chapter 3 Regular Service Inspectionse
Identified
Value
Roll number 1080
(649 is Roll 1)
Roll number 3690
(653 is Roll 1)
Identified
Value
6
6
71
47
0
Detected Value
1000 - 1180
3600 - 3790
Detected Value
0 - 255
(6 = approximately 2 mm
(0.079 inches))
Note
1 byte = 0.339 mm
(0.0134 inches)
1 mm equals about 2.95
bytes
10 byte = 3.39 mm (0.13
inches)
0 - 255
(71 = approximately 3
mm (0.12 inches),
47 = approximately 2 mm
(0.08 inches))
Note
1 line equals about
0.0423 mm (0.017
inches)
1 mm (0.039 inches)
equals about 23.6 lines
100 lines equal about
4.23 mm (0.17 inches)
1: Notify
0: Do not notify
2-41