(5)
Jam code 3403/3404 problem analysis
After the paper supply starts from the Roll x (x: roll number), PS04 detected paper earlier than
the prescribed time.
Check for improper paper installation and check for any remnants of paper particles in
PS04.
Check the cut at the front edge of the paper for:
- Folded end;
- Curved cut line; and
- Jagged edges
If there is a problem with the cut, perform (3) 3042-3047 problem analysis and check the
cutter's home position as well as its operation.
Select Sensor in Engine Maintenance mode.
Monitor PS04 (paper jam 4 sensor).
Does the display change between On and Off?
Yes
Select Actuator in Engine Maintenance mode, and operate FM01 and FM02 with On 1 (in
paper feed direction).
Does FM01 and FM02 run with On 1 (paper feed direction)?
Yes
Check the paper path to PS04.
Check the pressure of the roller (pinch).
5-30
No
◆ Check for short and open status on the CBL-CUT1.
◆ Check the installation of PS04 and the lever configuration.
If there are no problems, replace PS04.
No
Perform 2011-201C problem analysis. (See subsection 5.3.1 (3).)