Ricoh MP C307 Field Service Manual page 1145

0: The current page is erased.
1: The entire file is erased.
2 RTI/CSI display priority
0: RTI 1: CSI
3 File No. printing
0: Enabled
1: Disabled
4 Action when authorized
reception is enabled but
authorized RTIs/CSIs are not yet
programmed
0: All fax reception is disabled
1: Faxes can be received if the
sender has an RTI or CSI
5- Not used
7
* This setting can be used for the client machine which has no FCU.
System Switch 1F (SP No. 1-101-032)
No Function
0 Not used
1 Report printout after an original jam during
SAF storage or if the SAF memory fills up
0: Enabled
1: Disabled
2 Not used
3 Received fax print start timing
(G3 reception)
0: After receiving each page
1: After receiving all pages
4- Not used
6
1: If the SAF memory becomes full during scanning for a memory
transmission, the file is erased and no pages are transmitted.
• This setting is effective only when Automatic Journal
printout is enabled but the machine cannot print the report
(e.g., no paper).
This bit determines which identifier, RTI or CSI, is displayed on the
LCD while the machine is communicating in G3 non-standard mode.
1: File numbers are not printed on any reports.
NOTE: The file numbers may not be printed in the sequential order.
If a customer does not like this numbering, select "0".
0: If the user has stored no acceptable sender RTIs or CSIs, the user
can select "ON" in the authorized reception setting but the setting
becomes invalid ("OFF"). The machine will not be able to receive any
fax messages.
If the customer wishes to receive messages from any sender that
includes an RTI or CSI, and to block messages from senders that do
not include an RTI or CSI, change this bit to "0", then enable
Authorized Reception.
Otherwise, keep this bit at "1 (default setting)".
Do not change the settings
Comments
Do not change the settings.
0: When an original jams, or the SAF memory overflows
during scanning, a report will be printed.
Change this bit to "1" if the customer does not want to have
a report in these cases.
Memory tx – Memory storage report
Parallel memory tx – Transmission result report
Do not change the settings.
0: The machine prints each page immediately after the
machine receives it.
1: The machine prints the complete message after the
machine receives all the pages in the memory.
Do not change the factory settings.
4.Service Tables
63