Ricoh MP C307 Field Service Manual page 1163

Communication Switch 14 (SP No. 1-104-021)
No Function
0 Inch-to-mm conversion during
transmission
0: Disabled, 1: Enabled
1- Not used
5
6- Available unit of resolution in
7 which fax messages are received
Bit 7 Bit 6
0 0
0 1
1 0
1 1
Communication Switch 15 – Not used (do not change the settings)
Communication Switch 16 – Not used (do not change the settings)
Communication Switch 17 (SP No. 1-104-024)
No Function
0 SEP reception
0: Disabled
1: Enabled
1 SUB reception
0: Disabled
1: Enabled
2 PWD reception
0: Disabled
1: Enabled
3- Not used
4
5 PSTN dial-in routing setting
Comments
0: In immediate transmission, data scanned in inch format are
transmitted without conversion.
In memory transmission, data stored in the SAF memory in mm
format are transmitted without conversion.
Note: When storing the scanned data into SAF memory, the fax unit
always converts the data into mm format.
1: The machine converts the scanned data or stored data in the SAF
memory to the format which was specified in the set-up protocol
(DIS/NSF) before transmission.
Do not change the factory settings.
For the best performance, do not change the factory settings.
The setting determined by these bits is informed to the transmitting
terminal in the pre-message protocol exchange (in the DIS/NSF
Unit
frames).
mm
inch
mm and inch
Not used
Comments
0: Polling transmission to another maker's machine using the SEP
(Selective Polling) signal is disabled.
0: Confidential reception to another maker's machine using the
SUB (Sub-address) signal is disabled.
0: Disables features that require PWD (Password) signal
reception.
Do not change the settings.
1: The machine sets multiple PSTN dial-in numbers in the PSTN
4.Service Tables
81