Ricoh MP C307 Field Service Manual page 1140

4.Service Tables
6 Conditions for printing the protocol
dump list
0: Print for all communications
1: Print only when there is a
communication error
7 Not used
System Switch 0A (SP No. 1-101-011)
No Function
0- Not used
3
4 Dialing on the ten-key pad
when the external
telephone is off-hook
0: Disabled 1: Enabled
5 On hook dial
0: Disabled 1: Enabled
6- Not used
7
System Switch 0B - Not used (Do not change the factory settings.)
System Switch 0C - Not used (Do not change the factory settings.)
System Switch 0D - Not used (Do not change the factory settings.)
System Switch 0E (SP No. 1-101-015)
No Function
0- Not used
1
2 Enable/disable for direct
sending selection
0: Direct sending off
1: Direct sending on
3 Action when the external
handset goes off-hook
0: Manual tx and rx operation
58
may recognize that fax data is gone due to a power failure.
This switch becomes effective only when system switch 00 bit
6 is set to 1.
1: Set this bit to 1 when you wish to print a protocol dump list
only for communications with errors.
NOTE: The memory size is limited. Use this bit switch only
when some log reports are necessary.
Do not change this setting.
Comments
Do not change these settings.
0: Prevents dialing from the ten-key pad while the external telephone is
off-hook. Use this setting when the external telephone is not by the
machine, or if a wireless telephone is connected as an external telephone.
1: The user can dial on the machine's ten-key pad when the handset is off-
hook.
0: On hook dial is disabled.
Do not change these settings
Comments
Do not change the settings.
Direct sending cannot operate when the capture function is on during
sending. Setting this switch to "1" enables direct sending without capture.
Setting this switch to "0" masks the direct sending function on the
operation panel so direct sending with ScanRouter cannot be selected.
0: Manual tx is possible while the external handset is off-hook. However,
manual tx during handset off-hook may not be sent to a correct direction.
Manual tx is not possible.