Ricoh MP C307 Field Service Manual page 1120

3.Troubleshooting
Code
22- Original length exceeded the maximum
00 scan length
22- Memory overflow while receiving
01
22- Tx or rx job stalled due to line
02 disconnection at the other end
22- The machine cannot store received data
04 in the SAF
22- No G3 parameter confirmation answer
05
23- Data read timeout during construction
00
25- The machine software resets itself after a
00 fatal transmission error occurred
F0- V.34 modem error
xx
F6- SG3 modem error
xx
38
Meaning Suggested Cause/Action
been registered.
• Register the DNS server for the remote machine or
configure an IP address of the remote machine.
• Divide the original into more than one page.
• Check the resolution used for scanning. Lower the
scan resolution if possible.
• Add optional page memory.
• Wait for the files in the queue to be sent.
• Delete unnecessary files from memory.
• Transfer the substitute reception files to an another
fax machine, if the machine's printer is busy or out of
order.
• Add an optional SAF memory card or hard disk.
• The job started normally but did not finish normally;
data may or may not have been received fully.
• Restart the machine.
• Update the ROM
• Replace the FCU.
• Defective FCU board or firmware.
• Restart the machine.
• Replace the FCU.
• Update the ROM
• Replace the FCU.
• Replace the FCU.
• Update the SG3 modem ROM.
• Replace the SG3 board.
• Check for line noise or other line problems.
• Try communicating another V.8/V.34 fax.