Ricoh MP C307 Field Service Manual page 1142

4.Service Tables
System Switch 11 (SP No. 1-101-018)
No Function
0 TTI printing position
0: Superimposed on the page data
1: Printed before the data leading
edge
1- Not used
2
3 TTI used for broadcasting
0: The TTIs selected for each
Quick/Speed dial are used
1: The same TTI is used for all
destinations
4- Not used
7
System Switch 12 (SP No. 1-101-019)
No Function
0- TTI printing
7 position in the
main scan
direction
System Switch 13 - Not used (do not change these settings)
System Switch 14 - Not used (do not change these settings)
System Switch 15 (SP No. 1-101-022)
No Function
0 Not used
1 Going into the Energy Saver mode
automatically
0: Enabled
1: Disabled
60
Comments
Change this bit to 1 if the TTI overprints information that the
customer considers to be important (G3 transmissions).
NOTE: If "1" is selected, it is possible that sent data is printed on
two sheets of paper.
Do not change these settings.
1: The TTI (TTI_1 or TTI_2) which is selected for all destinations
during broadcasting.
Do not change these settings.
Comments
TTI: 08 to 92 (BCD) mm
Input even numbers only.
This setting determines the print start position for the TTI from the left edge of the
paper. If the TTI is moved too far to the right, it may overwrite the file number
which is on the top right of the page. On an A4 page, if the TTI is moved over by
more than 50 mm, it may overwrite the page number.
Comments
Do not change the settings.
1: The machine will restart from the Energy Saver mode
quickly, because the +5V power supply is active even in the
Energy Saver mode. The LED of the operation switch is
flashing instead of entering Energy Saver mode.
N can be between 00 - FF(H)
Default setting: 02(H) = 512 KB