Renault Duster 2007 Manual page 1107

UCH
Vdiag No.: 09
• Visual inspection of the sealing:
(Only for watertight connectors)
Check for the seal on the connection (between the 2 parts of the connection).
– Check the seal at the back of the connectors:
joints
– (1 for each wire), check that the unit joints are present on each electrical wire and that they are
For unit
correctly positioned in the opening (level with the housing). Check that plugs are present on openings which are
not used.
grommet
–
For a seal (one seal which covers the entire internal surface of the connector), check that the seal is present.
gel
–
For seals, check for gel in all of the openings without removing the excess or any protruding sections (it does not matter
if there is gel on the contacts).
hotmelt
–
For sealing (heat-shrink sheath with glue), check that the sheath has contracted correctly on the rear of the
connectors and electrical wires, and that the hardened glue comes out of the side of the wire.
– Check that there is no damage to any of the seals (cuts, burns, significant deformation, etc.).
If a fault is detected, consult Technical Note 6015A, Repairing electrical wiring.
FAULT FINDING LOG
IMPORTANT
Any fault on a complex system requires thorough fault finding with the appropriate tools.
The FAULT FINDING LOG, which should be completed during the fault finding procedure,
ensures a record is kept of the procedure carried out. It is an essential document when
IMPORTANT!
consulting the manufacturer.
IT IS THEREFORE ESSENTIAL THAT THE FAULT FINDING LOG IS FILLED OUT EVERY TIME IT IS
REQUESTED BY TECHLINE OR THE WARRANTY RETURNS DEPARTMENT.
You will always be asked for this log:
– when requesting technical assistance from the Techline,
– when requesting approval before replacing parts for which approval is compulsory,
– to be attached to monitored parts for which reimbursement is requested. The log is needed for warranty
reimbursement, and enables better analysis of the parts removed.
MR-453-X79-82D000$010.mif
V1
ACCESS – SAFETY
Fault finding – Introduction
82D-7
82D