Fault Finding - Programming - Renault Duster 2007 Manual

UCH
Vdiag No.: 09
UCH PROGRAMMING PROCEDURE
The UCH programming procedure is carried out using the diagnostic tool.
– Establish dialogue with the UCH computer.
– In the menu Special commands, select the command SC004 Program UCH.
The tool displays Remove the key from the anti-theft switch,
The tool displays Please enter the After-Sales code. With the ignition off, enter the secret After-Sales code
and validate.
If the code format is correct, the tool displays Insert a key which has already been programmed to the vehicle
and the programming procedure starts.
The tool displays UCH programming completed, please start key programming procedure, the UCH is coded.
Enter key programming mode to allocate the other keys (maximum of three keys). Several seconds may elapse
before this message appears.
IMPORTANT:
The maximum delay between each operation is 5 minutes, otherwise the procedure is cancelled.
Once the UCH is coded, it is impossible to clear or program it with a new code.
SPECIAL CASES
If the screen displays:
– The After-Sales code entered does not correspond with the key inserted. Check that you have entered
the code correctly and you have inserted a key belonging to the vehicle:
– The code read is incorrect or the UCH has already been coded on another vehicle.
– The UCH is not blank. Please start the key programming procedure: the UCH is already coded on this vehicle.
– Check the After-Sales code: the code entered is incorrect. Check, then try entering the data again,
– UCH programming failure, key cannot be used on this vehicle: the key code does not correspond to the code
entered (the key belongs to a vehicle from a different range).
– The key inserted is blank. Please present another key which has already been programmed to this vehicle:
the key is blank, present a key which has already been coded on this vehicle.
MR-453-X79-82D000$060.mif
V1
ACCESS – SAFETY
Fault finding – Programming
82D-15
82D