Renault Duster 2007 Manual page 1093

UCH
Vdiag No.: 09
ALP 11
NOTES
Check the condition of the bulb. Replace the bulb if it is defective (see MR 451 Mechanical, 81A, Rear lighting,
Rear light bulb: Removal - Refitting).
Check the presence and condition of fuse F27 (20 A) on component 1016.
Replace the fuse if the check is not correct.
Check the condition and connection of the connectors of the reversing lights switch, component code 155 (BVM5)
or 1109 (BVM6) and the rear right-hand light, component code 172 for left-hand drive or the rear left-hand light,
component code 173 for right-hand drive.
If the connector is faulty and there is a repair procedure (see Technical Note 6015A (Renault) or Technical Note
9804A (Dacia), Electrical wiring repair, Wiring: Precautions for repair), repair the connector, otherwise replace
the wiring.
Check for +12 V after ignition feed on the reversing lights switch, component code 155 or 1109 (depending on
equipment) on the following connection:
• AP9 of component 155 or 1109.
Check the continuity and insulation of the following connection:
• AP9 between components 1016 and 155 or 1109.
If the connection or connections are faulty and there is a repair procedure (see Technical Note 6015A, Electrical
wiring repair, Wiring: Precautions for repair), repair the wiring, otherwise replace it.
AFTER REPAIR
UCH_V09_ALP11
MR-453-X79-80D000$120.mif
V1
LIGHTING
Fault finding – Fault Finding Chart
The reversing light operates erratically
Only consult this customer complaint after a full check with the diagnostic tool.
There must be no present or stored faults.
Special note:
Use the Wiring Diagrams Technical Note for DUSTER.
Check the system operation.
80D-54
80D