JRC JMR-92 Series Field Service Manual page 566

Step 12 Run the Initial setting tool .
Connect your USB flash drive that contains the Initial setting tool and then start up the Display
Unit.
The Initial setting tool will launch automatically. Carry out initial setting for the Display unit by
referring "4.3.3.3 Initial Setting".
After initial setting is completed, turn OFF the Display unit and disconnect your USB flash drive.
Step 13 Recover the C Drive Image.
In order to apply the e-Token ID information to OS registry, recover the C Drive Image. Perform
system recovery by referring "Field Service Manual 5.3 Recovering the C Drive Image".
Step 14 Reconfigure the Display unit
Reconfigure the Display Unit. Set it up in accordance with the Licence file which the CCU had.
(RADAR / ECDIS / CONNING / AMS / MFD)
- RADAR
- CHART RADAR
- ECDIS
- CONNING
- AMS
- MFD
: Perform step 14-1, 14-2, 14-3, 14-5 and 14-7.
: Perform step 14-1, 14-2, 14-3, 14-5 and 14-7.
: Perform step 14-1, 14-2, 14-4, 14-5 and 14-7.
: Perform step 14-1, 14-2 and 14-5.
: Perform step 14-1, 14-2 and 14-6.
: Perform all corresponding reconfigure steps by referring the
Licence installed.
For how to check the Licences installed, refer
- Instruction Manual 21.1.3.2 Checking the enable/disable
statuses of the functions that have been installed
4-345 Chapter 4 Replacement procedure