JRC JMR-92 Series Field Service Manual page 606

4.3.4.7 Replacing HASP CYC-344
[Required Tools]
The tools shown in the following table are required for replacement work.
No. Name
1 Flat head screwdriver
2 Phillips screwdriver
3
Diagonal pliers
4
Cable-tie *1
5 USB flash drive *2
*1 A number of cable-ties may be required.
*2 Do not use Flash drives which are password protected or encrypted.
Before conducting replacement work, turn OFF the circuit breaker for the power supply of
the display unit.
Do not lose the screws as they will be needed again.
To prevent damage to the Unit during the replacement work, cut off cable-ties that fasten
the cable of the unit beforehand.
For the details that how to obtain the data files for HASP replacement, please contact our
head office or a nearby branch or local office beforehand.
Table Required Tools
Size
6 mm
Size #2
－
－
1 GB or more
4-385
Appearance
Chapter 4 Replacement procedure