Settings For Interswitch - JRC JMR-92 Series Field Service Manual

2.5.11. Settings for Interswitch

Since settings have been normally made upon shipment from
factory, do not edit them if it is not suggested from JRC office.
• It may cause a lower radar system performance.
4ch Interswitch NQE-3141-4A
Set dip switches SW11, SW12, and SW13 as shown below. For further information, see
Chapter 5 of Installation Manual
1)
SW11 setting (expansion mode, master/slave setting)
Chapter 2 System Configuration
Set all OFF.
2-84