Step 2
Replace the brake circuit.
Remove the cover on the port side and remove the cable that is connected to J1504 of the
motor driver circuit (7EPRD0034/35). Remove the two screws (M4) and replace the brake circuit
(CFA-255: resistor with cable). After replacing the circuit, reassemble the unit by following the
disassembly procedure in the reverse order. Do not forget to tighten the bolts or screws, and make
sure that the cables are connected.
CFA-255
Remove the four screws.
Chapter 4 Replacement procedure
Remove the eight
hexagonal screws.
Example: Port side cover removal
4-84
CBD-2000/2001
Remove the two screws.
J1504
CFA-255