JRC JMR-92 Series Field Service Manual page 805

6.6.2 Setting a serial port
In the "Serial Port" dialog, allocate the sensor to be connected for the serial port on CCU and the serial
port on SLC(Main/Sub)/ALC.
Serial port setting on CCU
Serial port setting on SLC/ALC
[Setting a serial port on CCU]
Setting Item
Gyro 1. Select the check box and enable the serial port for the
2. Select the sensor to be connected to the Gyro serial
LOG 1. Select the check box and enable the serial port for the
2. Select the sensor to be connected to the LOG serial
GPS 1. Select the check box and enable the serial port for the
2. Select a sensor to be connected to the serial port for
AIS 1. Select the check box and enable the serial port for the
2. Select a sensor to be connected to the serial port for
Chapter 6 Connection to External Navigation Equipment
Description of Setting
Gyro.
port from the [Sensor] combo box. When no sensor is
selected, select [-].
LOG.
port from the [Sensor] combo box. When no sensor is
selected, select [-].
GPS.
the GPS from the [Sensor] combo box. When no
sensor is selected, select [-].
AIS.
the AIS from the [Sensor] combo box. When no sensor
is selected, select [-].
CCU
6-20
SLC/ALC
Setting Value
To enable: Select.
To disable: Clear.
The sensors that can be
selected vary according to
the subsystem installation
status. Refer to "Table 4-2
Sensors that can be selected
on the Task Station".