JRC JMR-92 Series Field Service Manual page 874

The list of alert messages by alert type is shown below.
7.4.1 Alarms
Message
ACCA
ACCA (Back-up Navigator Call)
AIS (CPA/TCPA)
Cross Track
Crossing Safety Contour
Depth Below Keel
Dragging Anchor
End Of Track
End Of Track (Back-up Navigator
Call)
Failure of reduction in power
supply
Heading (Sensor Failure)
Heading (Sensor Failure,
Back-up Navigator Call)
POSN1 (Sensor Failure)
POSN1 (Sensor Failure,
Back-up Navigator Call)
POSN2 (Sensor Failure)
Speed (Sensor Failure)
Speed (Sensor Failure, Back-up
Navigator Call)
Track Control Stopped
Track Control Stopped (Back-up
Navigator Call)
TT (CPA/TCPA)
Location of
occurrence
TCS Warning for reaching wheel over line
TCS Warning for reaching wheel over line
(Back-up navigator call)
RADAR/AIS CPA/TCPA alarm
ECDIS The off-track distance from the planned
route exceeded the limit.
ECDIS Crossing the safety contour
ECDIS Alarm on the depth below the keel
ECDIS Exited from the dragging anchor monitoring
area
TCS 1 to 5 minutes before the arrival of the last
WP
TCS Not acknowledged by EOT alarm for 30
seconds
HCS
Failure or reduction of power supply
TCS Heading sensor failure
TCS Heading sensor failure (back-up navigator
call)
TCS POSN1 sensor failure
TCS POSN1 sensor failure (back-up navigator
call)
TCS POSN2 sensor failure
TCS Speed sensor failure
TCS Speed sensor failure (back-up navigator
call)
TCS TCS stopped.
TCS
TCS stop alarm was not acknowledged.
RADAR/AIS CPA/TCPA alarm
7-51
Explanation
Chapter 7 Troubleshooting