JRC JMR-92 Series Field Service Manual page 468

Step 2-1 In the case of *NKE-2632-H (port side): Remove the motor cable.
In the case of *NKE-2632-H, the HS motor driver unit must be removed.
[Port side] Remove the cable that is connected to the HS motor driver. Remove the four screws
(M5) and remove the motor driver.
HS モータ
NKE-2632-H
Motor driver circuit
ドライバー部
Port side
Step 3 (Starboard side) Open the power supply/interface circuit unit.
[Starboard side] By loosening the bolt (M4) and the two screws (M4) and removing the two
screws (M4), the power supply/interface circuit unit can be opened towards the front.
Power supply /
電源 I/F 回路部
interface circuit
Ｍ4 ねじ
Remove the two
screws (M4)
（2 箇所）外す
Starboard side
Chapter 4 Replacement procedure
左舷側
右舷側
Ｍ4 ボルト
Loosen the bolts
Loosen the two
screws (M4)
（2 箇所）緩める
4-248
M5 ねじ
Remove the four
screws (M5)
（4 箇所）
(M4)
緩める
Ｍ4 ねじ