JRC JMR-92 Series Field Service Manual page 432

Step 4 Close the power supply/interface circuit unit.
Loosen the M4 bolts and close the power supply/interface circuit unit. Fix only two screws (M4)
on the stern side.
Power supply / interface circuit
Tighten the two
screws (M4)
（2 箇所）締める
Step 5 Remove the transmitter-receiver unit.
[Starboard side] Remove the four screws (M5). Remove the bolt (M4). Remove the three
screws (M4).
Remove the bolt Ｍ4 ボルト
Ｍ4 ねじ
Remove the three
screws (M4)
（3 箇所）外す
Transmitter-receiver unit
送受信ユニット
Starboard side
Remove the cable that is connected to the transmitter-receiver unit and remove the unit towards
the front.
Chapter 4 Replacement procedure
電源 I/F 回路部
Ｍ4 ねじ
Starboard side
右舷側
(M4)
外す
右舷側
Ｍ4 ボルト
Loosen the bolts
(M4)
緩める
Remove the four
4-212
Ｍ5 ねじ
screws (M5)
（4 箇所）外す