JRC JMR-92 Series Field Service Manual page 436

Step 2 (Starboard side) Open the power supply/interface circuit unit.
[Starboard side] By loosening the bolt (M4) and the two screws (M4) and then removing the two
screws (M4), the power supply/interface circuit unit can be opened towards the front.
電源 I/F 回路部
Power supply / interface circuit
Ｍ4 ねじ
Remove the two
screws (M8)
（2 箇所）外す
Starboard side
Tighten the bolt (M4) and hold the unit while the power supply/interface circuit is opened.
Starboard side
右舷側
Chapter 4 Replacement procedure
右舷側
Power supply / interface circuit
4-216
Ｍ4 ボルト
Loosen the bolts
(M4)
緩める
Ｍ4 ねじ
Loosen the two
screws (M4)
（2 箇所）緩める
Ｍ4 ボルト
Tighten the bolts
(M4)
締める
電源 I/F 回路部