JRC JMR-92 Series Field Service Manual page 755

5.3.3 Starting the OS on the C Drive to Start This
Equipment (Automatic Recovery of Software)
Start the OS written back to the C drive to start this equipment.
1.
Click on the [OK] button in the dialog box that appears when write back finishes.
As the OS starts from the C drive, the applications and the various settings of the OS on the C
drive automatically recover.
The following dialog box appears during recovery operation.
System
Start the recovery of the software...
Caution
This equipment restarts during recovery operation. Do not perform any other operations
until recovery finishes.
Doing so may cause recovery to fail, leading to accidents.
When recovery is completed, the following messages are displayed.
System
Recovery succeeded.
Turn the power off and on again.
C-MAP charts has been initialized.
Set up the setting of the C-MAP
charts.
2.
Press the [Power] button on the operation panel to turn OFF the power to this equipment.
5.3.4 Setting C-MAP Again
Start this equipment again and perform settings associated with C-MAP.
Register the database and license again.
Also, perform update as necessary.
For further information, see "Additional Manual for Chart Installation 4.3 Importing C-MAP Ed.3".
Section 5 Software Update 5-12