JRC JMR-92 Series Field Service Manual page 806

Serial port
Gyro Heading Sensor(NMEA)
Heading Sensor(Gyro I/F)
LOG Log(NMEA)
Log(Gyro I/F)
Selector
GPS GPS 1
GPS 2
GPS 3
GPS 4
Selector
AIS AIS
(*1) Can be selected only when "Heading Sensor (Gyro I/F)" is selected for the Gyro port.
When "Log(Gyro I/F)" is selected, log data is acquired together with the Heading Sensor data
from the Gyro port and communication is not performed through the LOG port. Therefore, the
Diagnosis lamp, the Detail button, and the Monitor button are disabled.
[Setting serial ports on the SLC/ALC that is installed]
Setting Item
CH1 to CH8 1. Click on any of SLC1(M) to SLC4(M), SLC1(S) to
SLC4(S) and ALC1 to ALC4 tabs.
(IEC-61162-1)
2. Enable the serial port of the channel by selecting
the check box.
3. Select the sensor to be connected to the
channel from the [Sensor] combo box. When
no sensor is selected, select [-].
CH9/CH10 1. Click on any of SLC1(M) to SLC4(M), SLC1(S) to
(IEC-61162-2) SLC4(S) and ALC1 to ALC4 tabs.
2. Enable the serial port of the channel by selecting
the check box.
3. Select the sensor to be connected to the
channel from the [Sensor] combo box. When
no sensor is selected, select [-].
Gyro I/F Items are displayed only for SLC + "GIF" "RIF+GIF"
in Gyro I/F.
1. Click on any of SLC1(M) to SLC4(M) and
SLC1(S) to SLC4(S) tabs.
2. Enable the serial port of the channel by selecting
the check box.
3. Select the sensor (Gyro and Log) to be
connected to the channel from the [Sensor]
combo box. When no sensor is selected, select
[-].
Table 4-2 Sensors that can be selected on CCU
Sensor name
*1
Description of Setting
6-21
Devices required as the subsystem
(set to "installed" in the "Subsystem
Installation" dialog)
Heading Sensor 1
Log 1
Log Selector
GPS 1
GPS 2
GPS 3
GPS 4
GPS Selector
AIS
To enable: Select.
To disable: Clear.
The sensors
selected vary according to the
subsystem
Refer to "Table 4-3 Sensors that
can be selected on SLC/ALC".
To enable: Select.
To disable: Clear.
Sensors that can be selected:
Gyro: Heading Sensor 1/2
Log: Log 1/2
* The sensors that can be selected
vary according to the subsystem
installation status.
Chapter 6 Connection to External Navigation Equipment
Setting Value
that can be
installation status.