JRC JMR-92 Series Field Service Manual page 550

Step 1 Remove all the cables.
Remove all cables such as DVI cable and power cable from the rear face of the monitor.
AC Inlet (only NWZ-214-AC)
Step 2 Remove the Deco-Panels.
Using a flat head screwdriver, remove the top and bottom Deco-Panels of the monitor. The
Deco-Panels are fastened with six top and bottom stoppers. Insert the flat head screwdriver into
the driver insertion port at both edges and remove each Deco-Panel while raising the panel from
the edges little by little. Be aware that an attempt made to remove the panels by force may
damage the unit or break the Deco-Panels.
Remove the Deco-Panels carefully not to damage them. Hold down each Deco-Panel near
the stoppers, slowly apply force in the vertical direction while eliminating flexure as much as
possible, and then remove the panel.
DC In
4-329
RGB In DVI In
Chapter 4 Replacement procedure