JRC JMR-92 Series Field Service Manual page 820

4. Click on the [OK] button.
The selected function is assigned to each contact output. To change the function to be
assigned or cancel the assignment, click on the [Cancel] button.
5. The task station used by the [Task Station] combo box is chosen to the point of
contact which assigned the function.
If function is "Timer Reset", "All" can choose.
If function is "BZ Off Out(A/P)", it is fixed to "AMS & TCS".
Contact output that can
be selected
ACK Out
*2
BZ Off Out (BNWAS)
*2
BZ Off Out (A/P)
*2
BZ Off Out (Gyro)
BZ Off Out
Alarm Transfer
INS System Fail
Timer Reset
Position Sensor Failure
Position Monitor
Heading Sensor Failure
*1
Heading Monitor
Speed Sensor Failure
Table. Contact output that can be selected
ACK output (contact output to be output when the enabled alert are
approved)
Buzzer OFF output for BNWAS
Buzzer OFF output for Autopilot
Buzzer OFF output for Gyro Compass
Buzzer OFF output (Contact output that is output when the Silence
button is pressed on BAM. The contact output can be output even
without alarm occurrence.)
BNWAS ALARM output (contact output that is output from CAM to
BNWAS for transfer of alarm via BNWAS)
Buzzer OFF output (Contact output that is output when the Silence
button is pressed on BAM. The contact output is output also without
alarm occurrence.)
Timer reset notification
Position sensor failure alarm (automatic sailing)
Position monitor warning (position reliability deterioration)
Heading sensor failure alarm (automatic sailing)
Heading alarm
Speed sensor failure alarm (automatic sailing)
6-35
Description
Chapter 6 Connection to External Navigation Equipment