JRC JMR-92 Series Field Service Manual page 818

• Alarm Transfer (Contact output that is output from CAM to BNWAS to transfer the alarm
via BNWAS)
• Back-up Navigator Call (Alarm that is output when Back-up Navigator Call occurs due to
non-acknowledgement of Cross Track/ACCA/EOT/Position Monitor/TCS Stop/ECDIS Fail
that is necessary for TCS)
6.7.3 Enabling the contact output for PWR FAIL of a
CCU
1. Select the [PWR FAIL] (power fail) check box.
2. Select the function to be assigned:
• Power Fail (Alarm issued if the main AC power supply fails)
• INS System Fail (Alarm to notify that alert notifications cannot be transmitted to BNWAS via
the SLC/ALC)
(For details of INS System Fail, refer to "4.8 CAM Configuration and Setting." in the
Installation Manual)
• Back-up Navigator Call (Alarm that is output when Back-up Navigator Call occurs due to
non-acknowledgement of Cross Track/ACCA/EOT/Position Monitor/TCS Stop/ECDIS Fail
that is necessary for TCS)
6.7.4 Selecting the function to be assigned to each
contact input of the SLC/ALC
1. Select any of the SLC1(M) to SLC4(M), SLC1(S) to SLC4(S), and ALC1 to ALC4
tabs.
2. Select the [Contact Input] tab.
3. Select the function to be assigned to each contact input from the [Contact 1] to
[Contact 4] combo boxes:
• BZ Off In (BNWAS) (Buzzer Off input from BNWAS)*1
• BZ Off In (A/P) (Buzzer Off input from Autopilot) *1
• BZ Off In (Gyro) (Buzzer Off input from Gyro)
• PWR ACK IN (PWR ACK input)
• FWD/AFT Switch (FWD/AFT console switch input)
• NAV. Mode Switch(Mode of Azimuth Thruster switch input to display information
monitoring window)
(*1) Refer to "4.8 CAM Configuration and Setting" in the Installation Manual.
Active/Inactive of each function is indicated by the diagnosis lamp.
Lit in green: Active
Off: Inactive
4. The task station used by the [Task Station] combo box is chosen to the point of
contact which assigned the function.
In the case of the item referred to at all the task stations, "All" is chosen.
6-33 Chapter 6 Connection to External Navigation Equipment