JRC JMR-92 Series Field Service Manual page 810

Parity
Stop Bits (Stop Bit Length)
Buffer Size
Time Out
Checksum
Subsystem
Primary/Secondary
Sentence
Access Source
Serial port on CCU
Gyro (when Heading Sensor (NMEA) is
selected)
Gyro (when Heading Sensor (Gyro I/F) is
selected)
Log (when Log (NMEA) is selected)
GPS
AIS
Selector
Serial port on SLC/ALC
CH1-8
CH9/10
Gyro I/F
Select the parity of the corresponding serial port
from the combo box.
Select the stop bit length of the corresponding
serial port from the combo box.
Enter the buffer size of the corresponding serial
port in the box.
Enter the time-out duration of the corresponding
serial port on the box.
Select the check box and enable the checksum
of the sentence of the corresponding serial port.
This item is displayed only when "Alert(from
Subsystem)" or "Alert(to CAM)" is selected as
the sensor.
Select a device for alert handling. For details,
refer to "4.8 CAM Configuration and Setting."
Displayed only when "IAS(MODBUS)" is
selected for the sensor.
Set Primary/Secondary for the input from IAS.
Set the type of alert sentence.
If "-" is selected, no alert checks are made.
Displayed only when "Alert(to BNWAS)" is
selected for the sensor.
Select the equipment that communicates with
BNWAS.
When the system configuration does not contain
CAM, select ECDIS. In other cases, select AMS.
Table Selectable baud rates
Serial port
6-25
None/Odd/Even
1/2
0 to 10240 bytes
0 to 999sec
To enable: Select.
To disable: Clear.
Subsystem installed (task
station and sensor)/BNWAS
Primary / Secondary
-/ALR/ALF
* The selection of "-"
AMS/TCS
Baud rate
4800/38400
Fixed to 38400
Fixed to 4800
Fixed to 4800
Fixed to 38400
Fixed to 4800
2400/4800/9600
2400/4800/9600/19200/38400
Fixed to 38400
Chapter 6 Connection to External Navigation Equipment
indicates that the type of
alert sentence is
unselected; it can be
selected only for general
sensors (e.g., GPS and
Log).