JRC JMR-92 Series Field Service Manual page 738

4.4.3.3 Clearing a radar antenna operation time
The total transmission time and the total motor rotation time of a radar antenna can be cleared.
Clearing the total transmission time of a radar antenna
1. Click on the [Clear TX Time] (resetting transmission time) button.
Clearing the total motor rotation time of a radar antenna
1. Click on the [Clear Motor Time] (resetting the motor rotation time) button.
4.4.3.4 Replacing a TXRX circuit of a radar antenna
Verify the total transmission time and the total motor rotation time of the radar antenna and use the
information as the guideline for replacement.
Acquiring the data of the total transmission time and the total motor rotation time from a radar
antenna
Click on the [TXRX To Display Unit] (transmitting from an antenna to a display unit)
button.
The data of the total transmission time and the total motor rotation time is acquired from the
antenna and is stored in a display unit. The time that is acquired is displayed on the [Saved
Time To Display Unit] display section.
Transmit:
Motor Rotate: Total motor rotation time acquired from the radar antenna
Storing data of the total transmission time and the total motor rotation time in the radar antenna
Click the [Display Unit To TXRX] button (transmission from the display to the radar
antenna).
The total transmission time and total motor ration time saved in the display unit are saved to the
radar antenna.
If data is saved normally, the data saved in the display unit will be deleted.
When a command is sent from the display unit to the radar antenna, the transmission result is
displayed as follows.
Result waiting state: "Sending..." is displayed blinking at intervals of 1 sec.
When the result is success: "Completed" is displayed.
When the result is failure: "Not Completed" is displayed.
Total time acquired from the radar antenna
4-517 Chapter 4 Replacement procedure