JRC JMR-92 Series Field Service Manual page 537

Step 3 Remove the top and bottom screw covers of the monitor.
Using a 2 mm flat head screwdriver, remove the top and bottom screw covers of the monitor.
The top and bottom screw covers are fastened with a total of six stoppers. Insert a flat head
screwdriver into the driver insertion mouths at both edges and remove each cover by raising the
cover from the edges little by little. If you try to remove the covers by force, it may damage the
monitor or break the screw covers, so be careful.
Do not damage the screw covers while removing them. Hold down each screw cover near the
stoppers, slowly apply force in the vertical direction to eliminate flexure as much as possible,
and then remove the cover.
Chapter 4 Replacement procedure
Remove
4-316