Video Metadata (Beta) - Speco N8NRE User Manual

AI Event Management
"Pop-up Video", "Pop-up Message Box" and "E-mail". The alarm linkage settings are the same as the face detection alarm (see 11.1 Sensor Alarm
for details).
⑥ Click "Apply" to save your settings.

9.11 Video Metadata (BETA)

Please note that this feature is still in BETA and is not recommended for official implementation into your security environment.
Video Metadata (BETA): Humans, motor vehicles and non-motor vehicles in the video can be classified, counted and captured and the relevant
features can be extracted and displayed on the live interface.
① Click Start→Settings→AI/Event→AI Event→Video Metadata (BETA) to go to the following interface:
② Enable Video Metadata (BETA) and then set the schedule.
③ Set the detection area and any blocked areas.
Detection Area: 4 detection areas can be set. Targets that enter the pre-defined detection area will be counted and captured.
Blocked Area: 4 blocked areas can be set. Targets that enter the pre-defined blocked area will not be counted or captured.
To set a detection area: Select the number and then set the detection area. Click around the area you want to set as the alarm area on the image
(the alarm box should be a closed area).
To set blocked area: Select the number and then set the blocked area. The setup steps are the same as detection area settings.
Display OSD: If enabled, you can see the statistical information of humans, motor vehicles and non-motor vehicles on the screen. The statistical
OSD information can be customized as needed.
④ Set the reset information. Auto reset or manual reset can be set as needed.
⑤ Advanced settings. Click "Advanced" to enter the advanced settings interface. Select the recognition mode as needed. Interval mode and instant
mode can be selectable.
Interval mode: the system will push the captured picture to the live interface according to the set interval time.
Instant mode: the system will push the captured picture immediately once a target is detected.
⑥ Set the detection target and sensitivity.
⑦ Select the attribute information of the target. When the target is detected, the information you select will be displayed under the captured
image.
⑧ Click "Apply" to save your settings.
66
NVR User Manual