Basic Operation Guide; Startup & Shutdown; Startup; Shutdown - Speco N8NRE User Manual

Basic Operation Guide

2.1 Startup & Shutdown
Please make sure all connections are done properly before you power on the unit. Proper startup and shutdown are crucial to extending the life of
your device.

2.1.1 Startup

① Connect the output display device to the VGA/HDMI interface of the NVR.
② Connect the mouse and power. When powered on, the device will boot and the power LED would turn blue.
③ EZ setup window will pop up (you should select the display language the first time you use the NVR). Refer to 3.1 EZ Setup for details.

2.1.2 Shutdown

You can power off the device by using remote control or mouse.
By remote control:
① Press Power button. This will take you to a shutdown window. The unit will power off after clicking "OK" button.
② Disconnect the power.
By mouse:
① Click Start→Shutdown to open the Shutdown window. Select "Shutdown" in the window. The unit will power off after clicking "OK" button.
② Disconnect the power.

2.2 Remote Control

① Uses two AAA size batteries. (Not included)
② Open the battery cover of the remote control.
③ Place batteries. Please note the polarity (+ and -) and insert properly.
④ Replace the battery cover.
Key points to check in case the remote doesn't work.
1. Check your batteries polarity.
2. Check the remaining charge in the batteries.
3. Check IR controller sensor for any masking.
If it still doesn't work, please contact your distributor.
Note that the remote control is the same for all units of the same model. Be sure to point the IR sensor of the remote control directly towards the IR
receiver of the NVR you wish control if you have multiple devices. It's also recommended to place the recorders away from each other if possible.
There are two kinds of remote controllers. The interface is shown below.
2 Basic Operation Guide
Button
REC Record manually
Search Enter search mode
MENU Enter menu
Exit Exit the current interface
ENTER Confirm the choice or setup
Direction button Move cursor in setup
ZOOM Zoom in
PIP Currently no function
Control playback. Play (Pause)/Next Frame/Speed
Up/Stop/Previous Frame/Speed Down
Multi Choose multi screen display mode
Next Switch the live image
SEQ Go to sequence view mode
INFO Get information about the device
4
Function
NVR User Manual