Add/Edit Camera Group; Add Camera Group; Edit Camera Group; Ip Planning - Speco N8NRE User Manual

Camera Management
IP PoE cameras directly connected to the PoE ports of the NVR will be displayed automatically in the camera list. Refer to the picture above. The PoE
camera directly connected to the PoE port has a prefix shown before its camera name. The prefix consists of PoE plus PoE port number. A PoE camera
directly connected to the PoE port cannot be deleted from the camera list manually.
⚫ An IP camera directly connected to the PoE port of the NVR through private protocol will be shown automatically in the camera list.
⚫ One of two conditions must be met for an IP camera directly connected to the PoE port of the NVR through ONVIF protocol to be shown
automatically in the camera list:
✓ The IP camera directly connected to the PoE port is in the same network segment with the internal Ethernet port.
✓ The DHCP (obtain an IP address automatically) of the IP camera directly connected to the PoE port is enabled.
If the IP camera directly connected to the PoE port cannot be displayed automatically in the camera list, please refer to Q6 in Appendix A FAQ for
details.

4.2 Add/Edit Camera Group

4.2.1 Add Camera Group

Click "Edit Camera Group" in the above interface to go to the interface as shown below.
Click to open the window below. Set the group name and dwell time (the dwell time of the camera group sequence view) in the window. Check
the cameras and then click "Add" to add group. Click

4.2.2 Edit Camera Group

Click to modify the group information such as group name and dwell time. Click

4.2.3 IP Planning

Some models may not support this function.
to view the cameras in the group after adding group.
16
to delete the group.
NVR User Manual