Image Settings; Mask Settings - Speco N8NRE User Manual

Live View Introduction

5.3.2 Image Settings

Click Start→Settings→Camera→Image→Image Settings to go to the interface below. Select the camera and then set the brightness, contrast,
saturation and hue of the camera. Click "Advanced" button or
interface and then set the relevant items. Please refer to 5.3.4 Image Adjustment for detailed introductions of these items.
You can click "Default" to restore the image settings to the default factory settings.

5.3.3 Mask Settings

Some areas of the image can be masked for privacy. Up to four mask areas can be set for each camera. Click Start→Settings→Camera→Image→Mask
Settings to go to the interface as shown below. Select the camera and enable the mask. Click "Draw" button and then drag the mouse on the image
area to set the mask area; click "Delete" button to delete the mask areas; click "Apply" to save your settings.
in the camera list on the right side of the interface to open "Image Adjust"
22
NVR User Manual