Plate Database Management - Speco N8NRE User Manual

AI Event Management
⚫
Set the schedule.
⚫
Set the area and plate exposure as needed.
Set the alarm area. Drag the mouse to draw a detection area. Click "Clear" to delete the alarm area.
Set the blocked area. Select the number and then draw a blocked area. Up to 4 areas can be set up. After you set the blocked area, this area
will not be detected.
Click "Display all area" to view all blocked and detection areas.
Click "Clear All" to clear all blocked and detection areas.
⚫
Check "Capture plate absence vehicle" as needed.
⚫
Set the plate size by defining the maximum value and the minimum value (The default size range of a single plate occupies from 5% to 50% of
the entire image).
⚫
Display range: if enabled, the set maximum detection box and the minimum detection box can be displayed on the left window.
⚫
Click "Advanced" to set the recognition mode as needed (only some LPR cameras support).

9.2.2 Plate Database Management

In the LPR interface, click the "Plate Database" tab to go to the plate database management interface shown below.
For the first time, you can click "+" or "Add Group" to add groups.
Add plates to each group:
① Click
to extend the group. Click "Add Plate" to open the following window:
58
NVR User Manual