Upnp Report Access; Onvif - Speco N8NRE User Manual

Device Management
Platform Access
① Set "Access Type" as "Platform Software" and select "Enable" as shown below.
② Check the IP address and port of the transfer media server in the NVMS. The default server port for auto report is 2009. If it is modified, please
go to the transfer media interface to verify.
③ Enable the auto report in the NVMS when adding a new device. Then self-define a device ID and complete the remaining information of the
device in the NVMS.
④ Enter the above-mentioned server address, port and report ID in the server interface. Then click "Apply" to save your settings. Now the NVMS
system will automatically connect this device.

14.1.11 UPnP Report Access

In this interface, you can also access a third-party platform by UPnP Report. Click Start→Settings→Network→Integration→UPnP Report. If this one
is enabled, please enter the server address, port and manufacturer ID.

14.1.12 ONVIF

The device supports ONVIF (Profile G/T/S) and the model name can be searched on the ONVIF official website. After ONVIF is enabled, it can be
searched and connected to a third-party platform via ONVIF protocol.
Click Start→Settings→Network→Integration →ONVIF to enter the following interface:
103
NVR User Manual