Ez Setup & Main Interface; Ez Setup - Speco N8NRE User Manual

EZ Setup & Main Interface NVR User Manual
3 EZ Setup & Main Interface

3.1 EZ Setup

The disk icons will be shown on the top of the startup interface. You can view the number and status of each disk quickly and conveniently through
these icons ( : no disk; : unavailable disk; : RW available disk).
You can quickly configure the NVR by clicking "OK" to begin the EZ Setup process. You must configure the wizard if you start the NVR for the first time
(or click "Skip" to cancel the EZ Setup until the next time you login).
Click "OK" to start wizard. The setup steps are as follows:
① System Login. Set your own password when you use the wizard for the first time (the default username of the system is admin); select the login
username and enter a password.
Note: The default password level is "Strong". We highly recommend you create one with 8~16 characters (including upper case letters, lower case
letters, numbers and symbols) to increase the security of your product.
Click "Edit Security Question" to set questions and answers for admin password security. If you forget the password, please refer to Q4 in Appendix
A FAQ for details.
Click "Next" to continue the wizard.
② Disk Settings. You can view the disk number, disk capacity of the NVR and serial number, and R&W status of the disk. Click "Format" to format
the disk. Click "Next" to continue. Then click "EZ Setup".
③ Network Settings. Select the network parameters as required. Check "Obtain an IP address automatically" and "Obtain DNS automatically" to
set the IP address and DNS automatically (the DHCP function of the router in the same LAN should also be enabled), or manually enter them. Enter
the HTTP port, RTSP port and Server port (please see 14.1.2 Port Configuration for details). Click "Next" to continue.
7