Target Counting - Speco N8NRE User Manual

AI Event Management
Crowd Density Configuration:
Alarms will be triggered if the crowd density exceeds the set threshold value in the pre-defined area.
① Click Start→Settings→AI/Event→AI Event→Crowd Density to go to the interface below.
② Select the camera, enable crowd density detection and set the schedule, duration, refresh frequency and alarm threshold.
Refresh Frequency: Refers to the refresh time of the detection result report.
Alarm Threshold: Alarms will be triggered once the percentage of the crowd density in a specified area exceeds the pre-defined threshold value.
③ Select the alarm area. Draw the alarm area for the crowd density detection. Refer to the interface shown below. Check "Draw Area" and then
drag the mouse to draw a rectangular area. Uncheck the "Draw Area" when you are finished. Click the "Clear" button to delete the alarm area.
④ Click Trigger Mode to configure crowd density detection alarm linkage items. Enable or disable "Record", "Snapshot", "Push", "Alarm-out", "Preset",
"Buzzer", "Pop-up Video" and "E-mail". The alarm linkage settings are the same as the face detection alarm (see 9.1.1 Face Detection Settings for
details).
⑤ Click "Apply" to save your settings.

9.7 Target Counting

Only some IPCs support this function.
⚫
People counting in the pre-defined area:
This function is used to detect, track and count the number of people entering or exiting a selected area on a video.
Note: Only specific IPCs support this function.
① Click Start→Settings→AI/Event→AI Event→Target Counting to go to the interface below.
② Select the camera, enable target counting detection and set the schedule, duration, sensitivity, statistic cycle, enter threshold, departure
threshold and retention threshold.
Statistic cycle: Options of Always, daily, weekly and monthly.
Manual Reset: The current number of people counted will be cleared and the statistic cycle will restart when you click the "Manual Reset" button.
③ Set the alarm area and entrance direction. Click "Draw Area" and drag the mouse to draw a rectangular area. Drag the rectangle to change its
position. Uncheck the "Draw Area" when you are finished drawing. Click "Clear" to clear the area. Click and drag the arrow or the other end of the
arrow line to change the direction people enter.
62
NVR User Manual