Remote Surveillance; Web Lan Access; Web Wan Access - Speco N8NRE User Manual

Remote Surveillance

15.1 Speco Blue app
① Enable NAT in the NVR. Refer to 14.1.8 NAT Configuration for details.
② Scan the QR Code through the Speco Blue App available for iOS and Android to easily and securely view your cameras.
③ Run the Speco Blue app, go to the "Add Device" interface and then click
Start→Settings→System→Information→Basic to view the QR Code of the NVR).
④ After scanning the QR Code successfully, enter the password to log into your mobile client.

15.2 Web LAN Access

① Click Start→Settings→Network→TCP/IP to go to the "TCP/IP" interface. Set the IP address, subnet mask, gateway, preferred DNS and alternate
DNS of the NVR.
② Open the Web browser on your computer, enter the IP address of the NVR in the address bar and then press enter to go to the login interface
shown below. You can change the display language on the top right corner of the login interface. Enter the username and password of the NVR in
the interface and then click "Login" to go to the live view interface.

15.3 Web WAN Access

① Set the network of the NVR. Please refer to 14.1.1 TCP/IP Configuration for details.
② Click Start→Settings→Network→NAT to go to the interface for NAT configuration and check "Enable". Click "Apply" to save your settings and
make note of the QR code number under the QR code. Via Internet Explorer, go to connect.specotech.cloud, input the QR code number, your
username and password to login.
15 Remote Surveillance
Notes: 1. Please make sure that the IP address of the NVR and the computer are both in the same
local network segment. For example, if the IP address of the computer is 192.168.1.41, the IP
address of the NVR should be set to 192.168.1.XXX.
2. If the HTTP port of your NVR is not 80 but another number, you need to input the IP address
plus port number in the IE address bar when accessing the NVR over a network. For example,
if the HTTP port is 81, you should enter http://192.168.1.42:81 in the address bar.
to scan the QR Code of the NVR (Go to
110
NVR User Manual