Speco N8NRE User Manual page 13

EZ Setup & Main Interface
If you use the NVR with the PoE network ports, the online status of the internal Ethernet port will be shown on the interface.
If the NVR has two or more network ports, you can select the network parameters as required. Network Fault Tolerance and Multiple Address settings
are available.
④ Other Network Settings.
➢
UPnP settings: Check "Enable" in the interface and enter the external ports and then click "Test" to test the effectiveness of the input information.
If the UPnP status states, "Invalid UPnP", the port number may be wrong. Click
UPnP". Refer to the picture below. If you know the external IP address of the NVR, enter the external IP address plus port in the address bar of
your browser to access the NVR. (please see 14.1.6 UPnP Configuration for details).
➢
DDNS Settings: Check "Enable" and then select the DDNS type. Enter the server address, domain name, username and password according to
the selected DDNS type. And then click "Register" or "Test" to test the effectiveness of the domain name. If it is effective, you can enter the
domain name in the address bar of your browser to access the NVR. (please see 14.1.4 DDNS Configuration for details).
Note: Make sure the router supports UPnP and that UPnP is enabled in the router. Set the NVR's IP address, subnet mask and gateway and so on
corresponding to the router.
⑤ Add Camera. Add cameras via PoE first before adding any cameras from the LAN. Speco cameras added via the PoE ports will automatically be
added to the corresponding channel. To add cameras from the LAN, make sure all cameras are set to DHCP. Click "Refresh" to refresh the list of online
IP cameras which are on the same local network as the NVR and then click
in the list. Click to delete the added camera. Click "Delete All" to delete all the added cameras.
to modify the port until the UPnP status turns to "Valid
to add the searched camera. Click "Add All" to add all the cameras
8
NVR User Manual