Upnp Configuration; 101; Nat Configuration - Speco N8NRE User Manual

Device Management

14.1.6 UPnP Configuration

By UPnP you can access the NVR through the web client which on the WAN via a router without port mapping.
① Click Start→Settings→Network→UPnP to go to the interface below.
② Make sure the router supports UPnP function and the UPnP is enabled in the router.
③ Set the NVR's IP address, subnet mask and gateway and so on corresponding to the router.
④ Check "Enable" in the interface as shown below and then click "Apply" button.
Click "Refresh" button to refresh the UPnP status. If the UPnP status is still "Invalid UPnP" after refreshing, the port number is wrong. Please change
the mapping type to "Manual" and then click
can view the external IP address of the NVR. Enter the external IP address plus port in the address bar of your browser to access the NVR (example:
http://183.17.254.19:81).
14.1.7 802.1X
If 801.1X is enabled, NVR data can be protected. When the NVR is connected to the network protected by IEEE 802.1X, user authentication is needed.
To use this function, the NVR must be connected to a switch supporting the 802.1x protocol. The switch can be considered as an authentication
system to identify the device in a local network. If the NVR connected to the network interface of the switch has passed the authentication of the
switch, it can be accessed via the local network.
Protocol type and EAPOL version: Please use the default settings.
Username and password: The username and password must be the same as the username and password applied for and registered in the
authentication server.

14.1.8 NAT Configuration

Click Start→Settings→Network→NAT to go to the interface for NAT configuration and check "Enable". Click "Apply" to save your settings and make
note of the QR code number under the QR code. Via a browser, go to connect.specotech.cloud, input the QR code number, your username and
password to login. Note that you will need to install a plugin through the browser to get this feature to work.
to modify the port until the UPnP status turns to "Valid UPnP". Refer to the picture below. You

101

NVR User Manual