Speco N8NRE User Manual page 38

PTZ
target image will be automatically zoomed in and centered on the screen until the target disappears from the screen. After that, the PTZ camera will
return to the tracking start position.
To set smart tracking:
1. Click Settings→Camera→Smart Tracking to go to the smart tracking interface.
2. Select the tracking mode and set the "still time" as desired.
Tracking Mode: Choose between PTZ Auto Tracking Priority or Manual PTZ Control Priority.
PTZ Tracking Priority: if this mode is selected, after enabling "Trigger track" in one of the following events you cannot control the PTZ by clicking
the buttons on the PTZ control panel in the live view interface.
Manual PTZ Control Priority: if this mode is selected, after enabling "Trigger track" in one of the following events, you can control PTZ by clicking
the buttons on the PTZ control panel in the live view interface during the process of smart tracking. After you stop controlling for 5 seconds, the
PTZ camera will return to the pre-defined detection area and start tracking again when detecting a target.
Still time: If it is enabled and the time is set, if the target stops or hides behind an obstacle, or the target tracking is complete and there is no target
appearing in the detection area during the set time, the PTZ camera will return to the tracking start position after the set time expires. During this
time, if there are targets moving the PTZ will continue tracking. If it is not enabled, when the target stops or there is no target appearing in the
detection area for 5 seconds, the PTZ camera will return to the start tracking position.
For example: At the stoplight, if a car is waiting for the red light for 30 seconds, and the "still time" is set as 20 seconds, the tracking will stop
following; however, if the "still time" is set as 40 seconds, when the red light changes to green and the car starts to move, the PTZ will continue
tracking this car.
3. Click Settings→AI/Event→AI Event. Select the AI PTZ camera and the event as needed (Line Crossing/Intrusion). For example: intrusion.
4. Enable the event, set the rule and then click "Locked". This button will be changed to "Unlock". Now the PTZ control panel in the above interface
will be activated. Set the detection area by clicking the directional buttons in the above interface. After that, click "Unlock" to lock the detection
area.
Note: The PTZ must be locked, or the smart tracking cannot take effect.
5. Click "Draw area" and then draw the intrusion region on the screen. After that, check "Trigger Track" and click "Apply" to save your settings.
6. Set the detection target.
7. Click "Apply" to save settings.
33
NVR User Manual