Tampering Detection; Fire Detection - Speco N8NRE User Manual

AI Event Management
In the interface above, you can send e-mail to a specified person on a daily/weekly/monthly basis regarding the target counting. Click "Add" to add
the recipient, and then enable "Send Email" and select "Send mode" and time.
⑨ Click "Apply" to save your settings.

9.8 Tampering Detection

Tampering Detection Configuration:
① Click Start→Settings→AI/Event→AI Event→Tampering to go to the following interface:
② Select the camera and detection duration and then enable the relevant detection as needed.
Scene Change: Alarms will be triggered if the scene of the monitor video has changed.
Video Blurred: Alarms will be triggered if the video becomes blurry.
Video Color Cast: Alarms will be triggered if the video becomes obscured.
③ Set the sensitivity of the exception detection.
④ Click "Trigger Mode" to configure exception alarm linkage items. Enable or disable "Record", "Snapshot", "Push", "Alarm-out", "Preset", "Buzzer",
"Pop-up Video" and "E-mail". The alarm linkage settings are the same as the face detection alarm (see 9.1.1 Face Detection Settings for details).
⑤ Click "Apply" to save your settings.

9.9 Fire Detection

Fire detection is only available if you are using the appropriate Speco Technologies' Thermal Camera. Please note this is only intended as a
supplement to official fire detection methods and should not be relied on as a primary alert source.
Fire Detection: Alarms will be triggered if the camera detects a fire source through the thermal imaging.
① Click Start→Settings→AI/Event→AI Event→Fire Detection to go to the following interface:
64
NVR User Manual