view interface to set the default playback time). Refer to the picture below. Drag the playback progress bar to change the playback time. You can also

click the right-click menu "Instant Playback" in the camera window and then set the instant playback time to play back the record.

8.2 Playback Interface Introduction

Click

on the tool bar at the top of the live view interface or click Start→Playback to go to the playback interface as shown below (click

the tool bar at the top of the live view interface to set the default playback time).

The panel on the left will show you the channel number and their recorded data coded by color. The bar that runs across them represents the

playback time being viewed. You can move this bar around. To export, highlight a section of the desired recording, click export and follow the prompts.

You can export single or multiple channels at the same time.

The added cameras will playback their recordings in the playback interface automatically. You can also add the playback camera manually. Click

in the playback window to open the "Add Camera" window. Check the cameras in the window and then click "Add" to add playback camera. The

system supports a maximum of 16 synchronous playback cameras.

The buttons on the tool bar (area ①) at the top of the playback interface are introduced in the table below.

8 Playback & Backup

NVR User Manual

on the tool bar at the top of the live

Table of Contents