Intrusion Detection - Speco N8NRE User Manual

AI Event Management NVR User Manual
① Click Start→Settings→AI/Event→AI Event →Line Crossing to go to the following interface:
② Select the camera, enable line crossing detection by IPC and set the duration.
③ Set the schedule.
④ Select the direction.
Direction: A<->B, A->B and A<-B optional. It is the crossing direction of the target that crosses over the alert line.
A<->B: the alarm triggers when the target crosses over the alert line from B to A or from A to B.
A->B: the alarm triggers when the target crosses over the alert line from A to B.
A<-B: the alarm triggers when the target crosses over the alert line from B to A.
⑤ Draw line. Refer to the interface shown above. Drag the mouse in the image to draw an alert line. Click the "Clear" to delete the alert line.
⑥ Click "Detection Target" to choose the detection target and the sensitivity. The detection target includes people, vehicle and non-vehicle. Only
some IPCs can detect human or vehicle separately. If the camera doesn't support this function, please skip this step.
⑦ Click "Advanced" to choose "Original picture" or "Target picture" on the SD card of the camera. (If your camera doesn't support this function,
please skip this step).
⑧ Click "Trigger Mode" to configure tripwire alarm linkage items.
⚫ Enable or disable "Record", "Snapshot", "Push", "Alarm-out", "Preset", "Buzzer", "Pop-up Video" and "E-mail". The alarm linkage settings are the
same as the face detection alarm (see 9.1.1 Face Detection for details).
⚫ Enable "IPC_Digital Deterrent" or "IPC_Light" as needed (only some IPCs support these two functions). To set the IPC voice and its times and
volume, please refer to 11.6.6 Digital Deterrent for details. To set the light flashing time and frequency of the IPC, please refer to 11.6.7 Light for
details.
⑨ Click "Apply" to save your settings.

9.4 Intrusion Detection

Intrusion Detection Configuration:
Alarms will be triggered if the people or vehicles intrude into the pre-defined area.
① Click Start→Settings→AI/Event →AI Event→Intrusion to go to the interface below.
② Select the camera, enable the intrusion detection by IPC and set the duration.
③ Set the schedule.
④ Select regional activities. "Appear" or "Cross" can be selected (if your camera doesn't support region entrance/exiting detection, "Cross" will
not be enabled). If "Cross" is selected, you can choose the crossing direction.
⑤ Select the alarm area. Up to 4 alarm areas can be set up.
⑥ Draw the alarm area of the intrusion detection. Refer to the interface shown below. Click around the area where you want to set as the alarm
area in the image (the alarm area should be a closed area).
60