Light; Alarm Server - Speco N8NRE User Manual

General Event Management
In this interface, you can set the schedule and volume of the local audio alarm. Click "Manage" to set the schedule. Click "Add" to upload the audio
file. Choose the uploaded audio file and then click "Listen" to listen to it; click "Delete" to delete this file.

11.6.7 Light

Click Start→Settings→Alarm→Event Notification→Light to go to the interface as shown below. In this interface, you can set the light's flashing time
and frequency when an alarm is triggered.

11.6.8 Alarm Server

Go to Alarm→Alarm Server interface as shown below.
Enable the alarm server and enter the server address and port of the alarm server. Next, select the protocol. If "Send Heartbeat" is enabled, set the
interval times. After that, test the effectiveness of the alarm server. After a successful test, please click "Apply". When an alarm occurs, the device
will transfer the alarm event to the alarm server. If an alarm server is not needed, there is no need to configure this section.
86
NVR User Manual