E-Mail; Display; Buzzer; Push Message - Speco N8NRE User Manual

General Event Management
② Set the delay time and the schedule of each alarm-out. You can click "Edit Schedules" to edit the schedules (see 7.1.2 Schedule Settings for
details).
③ Click "Apply" to save your settings. You can click "Test" to test the alarm output.

11.6.2 E-mail

Click Start→Settings→AI/Event→Event Notification→E-mail to go to the e-mail configuration interface. Set the e-mail address of the recipients. See
14.1.5 E-mail Configuration for details.

11.6.3 Display

Click Start→Settings→AI/Event→Event Notification→Display to go to the display configuration interface. Set the duration time of the pop-up video
and the pop-up message box. If your device supports two outputs, please set the output of the pop-up video as needed. After that, click "Apply" to
save your settings.

11.6.4 Buzzer

Click Start→Settings→AI/Event→Event Notification→Buzzer to go to the buzzer configuration interface. Set the delay time of the buzzer and then
click "Apply" to save your settings. You can click "Test" to test the buzzer.

11.6.5 Push Message

Click Start→Settings→ AI/Event →Event Notification→Push Message to go to the interface as shown below. Check "Enable" and then click "Apply"
to save your settings. If the Push Server is online, it will push messages to the mobile clients.
84
NVR User Manual