Speco N8NRE User Manual page 14

EZ Setup & Main Interface
Click to edit the searched IP camera as shown below left. Enter the new IP address, subnet mask, gateway, username and the password of the
camera. You can check "Sync to IPC" to modify the IP address of the IPC via different network segments for being in the same network segment as
the NVR. Click "OK" to save your settings.
Click to edit the added camera as shown above right. Enter the new camera name, IP address, port, username and the password of the camera.
You can click "Test" to test the accuracy of the input information. Click "OK" to save your settings. You can change the IP camera name only when
the added camera is online. Click "Next" to continue.
Tips：Please skip Step ⑥ and ⑦ if the NVR does not support RAID function.
⑥ Disk Mode. Click "Enable RAID" to enable the RAID function. Click "Next" to continue.
⑦ Create an array. Set the array name and select array type which including RAID0, RAID1, RAID5, RAID6 and RAID10. The global hot spares and
array capacity can also be viewed here. See 7.4 Disk for details. Click "Next" to continue.
⑧ EZ Record Settings. Two record modes are available: auto and scheduled.
Auto: Select one auto mode in the interface as shown below and then click "Next" to save your settings. Click "Advanced" to self-define record mode.
See 7.1.1 Mode Configuration for details.
Scheduled: Set the "Sensor Record", "Motion Record" and "Schedule Record" of each camera. Click "OK" to save. See 7.1.1 Mode Configuration for
9
NVR User Manual