General Event Management; Sensor Alarm; Motion Alarm; Motion Configuration - Speco N8NRE User Manual

General Event Management

11.1 Sensor Alarm

To ensure complete setup of the Sensor Alarm function, you should enable the sensor alarm of each camera and then immediately set up the alarm
handling for that camera.
① Click Start→Settings→Alarm→Sensor to go to the following interface:
② Select the alarm type (NO or NC) according to sensor trigger type.
③ Enable the sensor alarm of each camera and select the schedule.
④ Check the "Duration", "Record", "Snapshot", "Push", "Alarm-out" and "Preset" and enable or disable the "Buzzer", "Pop-up Video", "Pop-up
Message Box" and "E-mail" as required.
⑤ Click "Apply" to save your settings.
The configuration steps of the above-mentioned alarm linkages are as follows.
Duration: The interval time between adjacent motion detections. For instance, if the duration time is set to 10 seconds, once the system detects a
motion, it will trigger the alarm alarm and will not detect any other motion (specific to that camera) for 10 seconds. If there is another motion
detected during this period, it will be considered as continuous movement.
Record: If checked, the "Trigger Record" window will open automatically (you can also click the "Configure" button to open the window). Select a
camera on the left side and then click
cancel the trigger camera. Click "OK" to save your settings. The trigger camera will record automatically when the sensor alarm is triggered.
Snapshot: If checked, the "Trigger Snapshot" window will open automatically. You can configure the trigger camera in this window. The trigger
camera will capture images automatically when the sensor alarm is activated.
Push: If checked, choose ON or OFF. If ON, the system will send messages when the sensor alarm is triggered.
Alarm-out: If checked, the "Trigger Alarm-out" window will open automatically. The system will trigger the alarm-out automatically when the sensor
alarm is tripped. You need to set the delay time and the schedule of the alarm outputs. See 11.6.1 Alarm-out for details.
Preset: If checked, the "Trigger Preset" window will open automatically. Here you can configure the trigger preset for each camera. To add presets,
please see 6.2 Preset Setting for details.
Buzzer: If enabled, the recorder will emit an audible buzz when the sensor alarm is triggered. To set the delay time of the buzzer, please see 11.6.4
Buzzer for details.
Pop-up Video: After camera setup, the corresponding video will pop up automatically when the sensor alarm is triggered. To set the duration time
of the video, please see 11.6.3 Display for details.
Pop-up Message Box: If enabled, the corresponding alarm message box will pop up automatically when the sensor alarm is triggered. To set the
duration time of the message box, please see 11.6.3 Display for details.
E-mail: if enabled, the system will send an e-mail when the sensor alarm is triggered. Before you enable email, please configure the recipient's e-
mail address first (see 14.1.5 E-mail Configuration for details).

11.2 Motion Alarm

Motion Alarm: when a motion object appears in the specified area, it will trigger the alarm. You should enable the motion of each camera first and
then set the alarm handling of the camera to complete the whole configuration of the motion alarm.

11.2.1 Motion Configuration

① Click Start→Settings→Camera→Motion Settings to go to the following interface:
11 General Event Management
to set the camera as the trigger camera. Select the trigger camera on the right side or click
81
NVR User Manual
to