Face Database Management - Speco N8NRE User Manual

AI Event Management
Face Detection Alarm Linkage Configuration:
① Trigger "Record", "Snapshot", "Push", "Alarm-out", "Preset", "Buzzer", "Pop-up Video" and "E-mail" as needed.
Record: Click the "Configure" button to open that window. Select a camera on the left side and then click
camera. Select a trigger camera on the right side and then click
cameras will record automatically when faces are detected.
Alarm-out: Click the "Configure" button to open that window. The "Trigger Alarm-out" window will then pop up automatically. Configure the trigger
alarm-out in that window. The system will trigger the alarm-out automatically when faces are detected. You need to set the delay time and the
schedule of the alarm outputs. See 11.6.1 Alarm-out for details.
Preset: Click and then select the preset for each camera. To add presets, please see 6.2 Preset Settings for details.
Snapshot: If it is enabled, the current camera will capture images automatically when faces are detected.
Push: If it is enabled, the system will send messages when faces are detected.
Buzzer: if it is enabled, the system will begin to buzz when faces are detected. To set the delay time of the buzzer, please see 11.6.4 Buzzer for details.
Pop-up Video: if it is enabled, the system will open the corresponding video automatically when faces are detected. To set the duration time of the
video, please see 11.6.3 Display for details.
E-mail: if it is enabled, the system will send an e-mail when faces are detected. Before you enable the email, please configure the recipient's e-mail
address (see 11.6.2 E-mail for details).
Enable "IPC_Digital Deterrent" or "IPC_Light" as needed (only specific IPCs support these two functions). To set the IPC voice and its times and
volume, please refer to 11.6.6 Digital Deterrent for details. To set the light flashing time and frequency of the IPC, please refer to 11.6.7 Light for
details.
⑩ Click "Apply" to save your settings.

9.1.2 Face Database Management

This function is only available for the N8NRE/N16NRE/N32NRE.
① Click Start→Settings→AI/Event→AI Event→Face Recognition→Face Database to go to the following interface:
For the initial setup, click "+" or "Add Group" to add groups.
② To add targets for each group select a list and then click
to cancel the trigger camera. Click "OK" to save your settings. The trigger
to expand the list as shown below.
54
NVR User Manual
to set the camera as the trigger