Cabling A 14U Library Containing Scsi Drives; Cabling Of A 14U Library Containing Multiple Scsi Drives; Terminator 2 Module-To-Module; Communication Cable - IBM System Storage TS3310 Setup And Operator Manual

3. Install a module communication terminator in the lower receptacle of the lower
4. Install one end of the customer-supplied Ethernet cable (
5. Install one end of the drive fibre cable (
6. Install one end of the power cord (
7. Continue with "Step 5: Powering ON the Library" on page 3-22.

Cabling a 14U Library Containing SCSI Drives

To cable a 14U library (control module + 9U expansion module) with SCSI drives,
complete the following steps:
3
2
Figure 3-18. Cabling of a 14U library containing multiple SCSI drives
3-20
TS3310 Tape Library Setup and Operator Guide
module of your library (
page 3-19) in the Library Control Blade Ethernet port, then connect the other
end of the cable to your network.
fibre drive in the library, then connect the other end of the cable to your
network. Repeat this for every fibre drive in your library.
the receptacle in a power supply in your library, then connect the other end of
the cord to your power source. Repeat this for every power supply in your
library.
4
1
Module communication
1
terminator
Module-to-module
2

communication cable

Ethernet cable (customer
3
supplied)
1
in Figure 3-17 on page 3-19).
7
in Figure 3-17 on page 3-19) in a
5 6
and in Figure 3-17 on page 3-19) in
5
9
SCSI drive-to-host cable
6
Power cord (upper module)
7
Power cord (lower module)
8
3
in Figure 3-17 on
7
6
8