Control Module With Two Drive Sleds - IBM System Storage TS3310 Setup And Operator Manual

Figure 11-5. Control Module with two Drive Sleds
11-8
TS3310 Tape Library Setup and Operator Guide
1
1 Tape drive
Drive thumb screws
2
3 SCSI terminator
Note: The thumb screws must be aligned with the screw holes in the module.
If they are not aligned, the drive sled was not inserted correctly.
a. Perform "Returning a Library or Library Module to Normal Operations
after Repairs" on page 11-2
b. Check the new drive's LED to ensure that it functions correctly.
Note: Moments after you power on the library, when the library and drives
are booting up, the green LED blinks once per second. When the
drive is downloading library application code to the drive sled, the
amber LED is solidly lit and both the blue and green LEDs flash once
per second. Firmware begins to download as soon as the library
detects a new drive. A firmware download typically take up to 25
minutes.
c. Connect the host interface cables to the drive. In the example configuration
shown in Figure 11-5, the bottommost SCSI connector (
being used to link the module to the host and the SCSI bus terminator is
plugged in to the topmost connector (
d. Vary the drive online.
2
4
4 SCSI receptacle
Drive handle
5
3
in Figure 11-5).
5
3
4
in Figure 11-5) is